BILLION BIPAC 7100G DRIVER DOWNLOAD

It will refresh every two seconds. If you do not check this selection, remember to specify a static IP address, subnet Mask, and DNS setting for each of your local computers. Then you will see IKE Setup page as below figure. Page 55 Chapter 3 Configuration Add: Appendix Troubleshooting chapter, please contact the dealer where you purchased this product. Maximum Transmission Unit indicates the network stack of any packet is larger than this value will be fragmented before the transmission. Since your service provider might not support this test, your DSL modem could still work even if this test fails.

Uploader: Yozshumuro
Date Added: 24 September 2015
File Size: 21.29 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30733
Price: Free* [*Free Regsitration Required]

Appendix Troubleshooting chapter, please contact the dealer where you purchased this product. Please choose your local time zone and click Submit.

Hence, the following fields will be activated. Routing Table Chapter 3 Configuration 3.

Billion BIPAC G Manuals

In the Internet, every host has a unique and friendly name such as www. Comments to this Manuals Your Name. Please check Chapter 3.

  HP PRINTER C5180 DRIVER

Diagnostic Test Chapter 3 Configuration 3. By pressing ‘print’ button you will print only current page. The default IP address of router is If you do not check this selection, remember to specify a static IP gipac, subnet Mask, and DNS setting for each of your local computers.

In the Control Panel, double- click on Network and choose the Protocols tab. Enter the Ethernet type.

Billion Electric Company BIPAC 7100G User Manual

Select TCP if you want to scope for the connection-based application service on the remote server using the port number. Supports downstream transmission rates of up to 8Mbps and upstream transmission rates of up to Kbps.

Chapter 3 Configuration MTU: Snmp Chapter 3 Configuration 3. Click this button to add a new static routing. The range of remote IPs can be communicated. After click, next figure will 710g.

Billion BIPAC 7100G Manuals

This test will pass if response cell is received. Chapter 3 Configuration Add: Do not use the same power source for the device with other equipment.

  LEXMARK T360 DRIVER

Don’t show me this message again. It can support downstream transmission rates of up to 8Mbps and upstream transmission rates of up to Kbps. Session Name status will be displayed at the middle of this page to show the corresponding Session Name with its IP address.

Chapter 1 Introduction 1. It will refresh every two seconds. Chapter 3 Configuration 4. After the device is powered on, press it to reset the device or restore to factory default settings. It will refresh every ten seconds. The IP address is so hard to remember that you may just enter the friendly name www. Page 55 Chapter 3 Configuration Add: Check this will block all browsing requests from PCs Block: Double-click Local Area Connection.

The default value is seconds.